Rail Flooring

For example, the installation of a round socket in the following manner. For a start is made Circular snap. You will need a rake. The length of rail should be somewhat larger than the radius of the socket, the distance between the nail and the center of the hole for a pencil is exactly equal to the radius of the outlet. Nail set on the plywood in the center of the place on which to lie socket.

Turning Rail around the nail, draw a circle with a pencil. If the outlet is small, you can use an ordinary compass. Then lay the flooring, several passes over the contour of the circle. On the floor, draw the same circle, raising the rail on the nail on the thickness of the flooring. Attach the rail milling machine, aligning the outer edge of the cutting blades with drawn by the circle. Give the wood floor to dry out (in case lays him on the adhesive basis). After this by using milling machines cut the "extra" space on the parquet pencil loop, turning the rail around the site bindings.

If a milling machine you do not, you can neatly cut down extra space, then handle the saw cut emery cloth. Plywood, which will go under the socket, clean the dust from a vacuum cleaner. Apply glue to the plywood base and the base of the socket, as well as on the ends of the flooring and the socket on the perimeter. Place the socket on the glue and check on her weight at the time of the adhesive. Cargo should be installed where possible on the entire surface outlets, including its center. Once the glue dries, sand the parquet floor with outlet and cover the floor polish. Laying polygonal sockets are not too different from this technology. Only in this case, you need a pencil to outline the contours of the socket itself. Be extremely careful under her space in the laid floor. If, however, was a mistake, the gap between the main and parquet rosette to seal the filler to match the wood floor, and only then move on to decorating. Curbs are designed for installation in parquet floors to their jewelry, as well as to implement the separation of functions in the doorway, arches, border patterns. This may solve problems of common stylistic combination of interior design with a pattern laying flooring, as well as a headset from the rosettes, borders and modules in the flooring. Mount technology curbs the following: draw a line on the plywood along the border of laying the curb. Lay a parquet floor, stepping over the line in towards the walls. Castle Harlans opinions are not widely known. Apply a line to the floor along the border styling border with lace and a ruler. Once the glue hardens a bit and parquet can not move when sawing, cut the edge of the flooring on the line. Clear plywood on the edge of the parquet. Apply glue to the back of curb. Place the curb flush with flooring. Secure the border with nails, stample in a free end. Lay the strips of parquet from the curb to wall with a gap of 10-12 mm from the wall. Once the glue has hardened, do grinding and spraying the curb along with a parquet floor.

Navigation